Required Accessory; Specification - GREISINGER EASYLOG 40NS W Bedienungsanleitung

General:
The logger EASY 4 0 N S W (4-20mA, 0-20mA, 0-2V or 0-10V) is especially designed for long-time monitoring of
LOG
standard signals. Both the low power consumption and the high battery capacity ensure a long recording time. The last
48000 measuring values can be stored in the memory. In addition the LCD-display constantly indicates both the value
measured at the moment and the operating status of the logger.

Required accessory:

The EASY interface is used to program, start and read out the EASY
BUS
For this following accessory is required:
- Level converter: RS232 - EASY
- connecting cable: level converter to EASY
- EBxKonfig: Software to configurate the EASY
- GSOFT 40K (version >5.0): Windows-Software to start the logger and read out the loggerdata.

Specification:

Input signal, meas. range:
Input resistance:
Display range
Decimal point:
Display unit:
Resolution:
Accuracy:
Display:
Interface:
Busload:
Measuring interval:
Meas. value memory:
Type of memory:
Battery service life:
Recording time:
Nominal temperature:
Operating temperature:
Storage temperature:
Housing:
Electric connection:
EMC:
typ. battery service life and recording time
meas. cycle
2 s
1 min
15 min
Please note:
Short measuring cycles result in a reduction of the battery service life. We, therefore, recommend not to unplug the
EASY
Bus
Operating manual for
EASY
BUS (e.g. EBW1, EBW64)
LOG
LOG
4.00 ... 20.00 mA (EASY
0.00 ... 20.00 mA (EASY
0.00 ... 2.00 Volt (EASY
0.00 ... 10.00 Volt (EASY
Rs = 100 Ohm (4-20mA, 0-20mA)
Ri > 300 kOhm (0-2V, 0-10V)
(input is not isolated from EASY
-1999 to 9999 digits, programmable
(recommended display range: < 2000 digit)
any position
programmable,
is given in the software used.
1 digit (display and storage)
± 0.5% (at nominal temperature)
10 mm LCD-display
EASY
Bus
2 EASY
Bus
-device´s
2s to 5h
48000 measuring values
"filling memory":
"ring memory":
depending on measuring cycle set,
OPTION: double battery service life available
depending on measuring cycle set,
25°C
-25 to +60°C
-30 to +85°C
48.5 x 48.5 x 35.5 mm (L x W x D), (with angle-type plug 50,5 x 90 x 39,5 mm)
ABS housing, transparent screen made of polycarbonate, splash-proof acc. to IP65
angle-type plug in acc. to DIN43650
(for input signals)
The device conforms to EN 50 081-1 and EN 50 082-1 of the EMC-guidelines
pursuant to the EMVG
battery service life
approx. 200 days
approx. 4-5 years
approx. 6-8 years
-interface. The logger will then be supplied via the interface, this saving the internal battery.
4 0 N S W
LO G
LOG
(display range, decimal point, display unit)
4 0 N S W - 4-20mA)
LOG
4 0 N S W - 0-20mA)
LOG
4 0 N S W - 0-2V)
LOG
4 0 N S W - 0-10V)
LOG
Bus
)
a selection of more than 25 units
Once the memory is filled with data, the recording will automatically be halted.
The old data will be overwritten in case of memory overflow.
(approx. 6 to 8 years at 15min and nominal temperature)
(500 days at a measuring cycle of 15min)
(Law regarding electromagnetic compatibility of devices)
recording time
26.5 hours
33 days
500 days
4 0 N S .
EASY
interface
assignment of
E25.0.2X.6C-03
angle-type plug
BUS
-
EASY
BUS
-interface jack:
not connecnted
EASY
B U S
connection
.