Operating Elements & Connections - Omnitronic PAS PRO-DSP Bedienungsanleitung

4
OPERATING ELEMENTS & CONNECTIONS
1 Volume control SUB LEVEL for the
subwoofer level
2 Signal input
Balanced combo inputs (XLR/6.3 mm jack)
for connecting audio units with line level
output (e.g. mixers or preamplifiers).
3 Feed-through output LINK OUT
Balanced XLR jacks, connected in parallel
to the inputs, to connect another device,
e.g. a further active speaker system.
4 POWER indicator
5 SIGNAL indicator
6 Control LOW PASS
For adjusting the upper crossover
frequency (80-200 Hz) of the low-pass
filter.
Phase reversal switch
7
When the switch is engaged, the phase is
turned by 180°.
8 Power switch
9 Power input
Plug in the supplied power cable here.
10 Fuse
Only replace the fuse when the device is
disconnected from mains. Only use fuses
of the same rating and power. The correct
fuse value is specified on the rear panel.
15