Troubleshooting - Sunny VOSS.farming Bedienungsanleitung

English
Maintenance
• Clean the solar module regularly by using a soft cloth and a glass cleaner or
a mild cleaning solution mixed with water. This assures the efficiency of the
solar module.
• During the transportation of the energiser, protect the solar module to prevent
damage to the glass surface.
Storage
• If the energiser is stored for a longer period of time, the battery can discharge
itself and thus can become damaged.
• When not in operation the energiser should be stored indoors, if possible near
a window, so that the sunlight can shine on the solar module. If this is not
possible, the device should be simply stored in a cool dry place. The battery
should be fully charged and disconnected. The battery should be manually
charged every six months using a suitable charger.
Control LED
• The device releases an electric impulse under normal operating conditions
every 1,1 seconds, when the battery is fully charged or the Voltage is above
12V. The LED lights up concurrently with the impulses.
• At a battery voltage between 11.2 V and 12.0 V, the energiser emits a pulse
every 3 seconds. The "ECO Mode" is switched on and the LED continues to
flash at the same interval as the impulse. The battery should be recharged.
• Below 11.2 V the device does not emit impulses anymore and the LED
flashes rapidly, the battery must be recharged.
Warning!
Do not open the device yourself and do not carry out any repairs on the energiser!
For repairs and inspections, please contact your specialist dealer from whom you
bought the device.
22

5. Troubleshooting

Error Solution
The LED light flashes, but Please check if all connections and connectors of
the fence voltage is low. the fence and ground connections are firmly fixed
and whether they are in good condition. If neces-
sary, please remove rust.
Also make sure that the ground rod is almost
completely in the ground.
On the fence line, check if there are any leakages
due to trees, bushes or other vegetation and
remove them.
Check whether the energiser is strong enough to
power the required length of the fence. If neces-
sary, reduce the length of the fence or the number
of the fence lines. Alternatively, longer fences can
be divided into smaller separate sections, where
each is powered up by its own energiser.
Warning: never connect more than one energiser
to any one fence system.
The LED light does not Please check whether the device is switched on.
flash. If the battery is not sufficiently charged, then the
device is possibly in the battery protection mode.
Charge the battery by placing the solar module in
such a way that the module surface faces south
in the northern hemisphere and faces north in the
southern hemisphere. If this does not charge the
battery sufficiently, please remove the energiser
from the fence and charge the battery manually
using a battery charger.
If the battery is still not charged sufficiently, then
the battery must be changed. Before you insert a
new battery in the device, please fully charge the
battery using a suitable charger. If the LED of the
energiser still does not light up, please contact the
dealer.
English
23