ABL SLS4K40 Montageanleitung Und Bedienungsanleitung Seite 8

SLS4K40– Installation and User Guide
Specifications
Rated voltage
Quiescent current (POWER-DOWN)
Maximum current per channel
Maximum total current
Fuse
Connection technology X1...X10
Connection cross-section
Stripped length
Connection technology X11
Max. cable length
Ambient temperature (storage)
Ambient temperature (operation)
Relative humidity
IP rating
Dimming frequency
Dimming levels
Declaration of conformity
The light control SLS4K40 meets the requirements of following standards and regulations:
2000/53/EC
UN/ECE R10
ISO 7637-1:2002
ISO 7637-2:2011
ISO 16750-1:2006
ISO 16750-2:2010
ISO 16750-3:2007
ISO 16750-3:2010
12V= (9 ... 16.0V)
<1mA
3A
10A
750mA T internal, not replaceable
The supply terminal must be externally protected with 10A!
Tension spring terminal (for use of cables with a partial stripping)
solid
stranded
stranded with ferrule
6.0 mm
Pin connector LUMBERG 2,5 MSF/O 05
(for LUMBERG empty housing 3114 05 with crimp contacts 3111)
supply 2.5m
buttons and channels 10m
-30 ... 85°C
-20 ... 55°C
5 ... 95% (no condensation)
IP20
100Hz ± 10%
32
End-of-life vehicles
Radio interference (electromagnetic compatibility) of vehicles
Road vehicles - Electrical disturbances from conduction and coupling
- Part 1: Definitions and general considerations
- Part 2: Electrical transient conduction along supply lines only
Road vehicles - Environmental conditions and testing
- Part 1: General
- Part 2: Electrical loads
- Part 3: Mechanical loads
- Part 4: Climatic loads
0.1 – 2.5 mm²
0.2 – 2.5 mm²
0.2 – 1.5 mm²
Seite 8
Doc. No. 03 0020 01_C