SEC DVB-S Settop Box SB-1200 Bedienungsanleitung Seite 60

Figure 7. Connecting to Dish LNB
Before connecting to the power supply the receiver must be cabled completely.
Attention: The total current consumption of all devices (LNB, multiswitch, ...) connected to the
LNB-Input must not exceed 400mA. The connected antenna must be grounded correctly. Please
note the VDE prescriptions.
Warning: If, after connecting the receiver to the mains, the message "short circuit or
antenna input overload!" is displayed on the screen, then there is a short circuit in
12