Recording; To Keep A Subject In Focus - Sony MPK-DVF2 Bedienungsanleitung

Recording

POWER switch
AUTO FOCUS
ON/OFF button
REC lamp (red)
LEAK lamp
(yellow)
(1) Set POWER switch to ON.
(2) Press START/STOP button to start recording.
REC lamp (red) lights up during recording.
To stop recording
Press START/STOP button.
To zoom
Press ZOOM button.
Press T for telephoto (subject appears closer) and W for wide-angle (subject appears
farther away).
You cannot change the zooming speed of the camcorder.
Note on Photo recording (DCR-TRV8E/TRV9E/TRV10E/TRV890E/TRV900E only)
If you press PHOTO button when a still picture appears on the LCD screen or in the
viewfinder, the camcorder will record that still picture.
You cannot check the recorded picture by pressing PHOTO button lightly.
For details, please refer to the operating instructions supplied with your camcorder
When you use DCR-TRV8E/TRV10E/TRV890E/TRV900E, the memory photo function
does not work when your camcorder is placed in MPK-DVF2.

To keep a subject in focus

After you focus on a subject, press AUTO FOCUS ON/OFF button to set the camcorder
to manual focus mode.
Even if fish swim between the camcorder and the subject, you can still keep the subject
in focus.
Press AUTO FOCUS ON/OFF button again to set the camcorder to auto focus mode.
Note on before recording
Check that the equipment operates correctly and that there is no water leakage at a
depth of about one meter (3 feet) before you dive deeper.
Note on recording
Do not cover the control emitter or detector with your finger because the remote control
signal for operations is transmitted from the grip to the marine pack.
PHOTO button
ZOOM button
START/STOP button
13
GB
-GB