Routine Maintenance - LIGHTMAX Shaft 5R Bedienungsanleitung

LightmaXX Shaft 5R

7. Routine maintenance

Routine maintenance to the moving head light is strongly recommended .The equipments life span depends on the
working environment to a great degree .Therefore it's very important to keep routine maintenance.
Caution! Switch off the power supply before opening any lid.
1. Clean the optical parts
Optical parts should be wiped gently as coating surface is fragile which can be scraped easily .Devastating solvent
mustn't be applied because they can damage the plastic and coating surface.
Cleaning steps:
1、Turn off the power supply, cool it down thoroughly, open the lid.
2、Blow away the dust and floats with vacuum or blower.
3、Wipe off the graininess with odorless tissue or cotton saturated with rinsing or distilled water. Do not wipe surface,
blow away the floats with vacuum.
4、Wipe off the dust and odd parts with cotton soaked with Propanol, odorless tissue or glass cleaner .Residue dust
must be wiped off with distilled water then scrub it clean with soft cotton from center towards outside.
2. Clean the fan and air hole
Overheating protection caused by the fan air hole block can lead to moving head light stop working?
Wipe off the dust stuck in the fan and air hole with soft brush, cotton, vacuum or blower.
2. Cleaning regularly
Wipe off the dust from the light body, lens, reflector, inside, PCB regularly.
Fasten pendent parts, swing and twirling nuts regularly.
Add lubricant to the rolling parts regularly.
Check the working motor wires and connecting wires of large current .Be cautious of short circuit and ageing.
3. Gobo plate swabbing
In order to keep the gobo plate swirling continually and freely, swabbing should be taken every six months with
lubricant. Don't overuse the lubricant in case splash out while gobo plate swirling.
4. In order to keep light in the best working effectiveness and function, the key point is
clean the parts where dusts accumulate easily regularly .Wipe off the dust on gobo and
optical filter must with the soft cotton soaked with glass cleanser.
Warning: Don't use solvent or alcohol.
6. Deliver the light to professionals to carry out the routine maintenance after using the
light for one year. Including the followings:
A. Clean inside thoroughly
B. Replace and replenish the lubricant with excellent heat resisting one in the parts abraded or grinded easily.
C. Check inside components, wires, and mechanical parts etc thoroughly
D. Carry through electronic parts, optical parts and function test.
Beam Moving Head
28
______