Safety Information - LIGHTMAX Shaft 5R Bedienungsanleitung

2. Safety Information

T 40℃
a
IP20
T 100℃
c
• Installation
Make sure all parts for fixing the projector are in a good state of repair.
Make sure the point of anchorage is stable before positioning the projector.
The safety chain must be properly hooked onto the fitting and secured to the framework,
so that, if the primary support system fails, the fitting falls as little as possible.
If the safety chain gets used, it needs to be replaced with a genuine spare.
• MINIMUM DISTANCE OF ILL UMINATED OBJECTS
The projector needs to be positioned so that the objects hit by the beam of light are at
least 12 meters (39'4") from the lens of the projector.
• Minimum distance from flammable materials
The projector must be positioned so that any flammable materials are at least 0.50
meters (19, 7") from every point on the surface of the fitting.
• Mounting surfaces
It is permissible to mount the fitting on normally flammable surfaces.
• Maximum ambient temperature
Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
• IP20 protection rating
The fitting is protected against penetration by solid bodies of over 12mm (0.47")
in diameter (first digit 2), but not against dripping water, rain, splashes or jets of water
(second digit 0).
• Protection against electrical shock
Connection must be made to a power supply system fitted with efficient grounding (Class
I appliance according to standard EN 60598-1).
It is, moreover, recommended to protect the supply lines of the projectors from
indirect contact and/or shorting to earth by using appropriately sized residual current
devices.
• Connection to mains supply
Connection to the electricity mains must be carried out by a qualified electrician.
Check that the mains frequency and voltage correspond to those for which the projector
is designed as given on the electrical data label.
This label also gives the input power to which you need to refer to evaluate the
maximum number of fittings to connect to the electricity line, in order to avoid
overloading.
• Temperature of the external surface
The maximum temperature that can be reached on the external surface of the fitting, in
a thermally steady state, is 100°C (212°F).
• Maintenance
Before starting any maintenance or cleaning work, interrupt the power from the mains
supply.
To avoid getting burnt, do not remove any parts of the fitting for at least 35 minutes,
after switching off the device. After this time, the chance of an exploding Lamp is
improbable.
The fitting is designed, to hold in any splinters produced by an exploding Lamp. The
lenses must be in good condition. Visible damages have to be replaced with genuine
spares.
• Lamp
The Fitting mounts a high-pressure lamp, which needs an external igniter. This igniter is
fitted onto the device.
Please read the "operating instructions", which are provided by the lamp manufacturer,
carefully.
Replace the lamp immediately, if it's damaged or deformed by heat.
All in this Manual mentioned Products are conform to the European Community
Directives to which they are subject:
• Low Voltage 2006/95/CE
• Electromagnetic Compatibility 2004/ 108/CE
18