Preparation And Set Up - Neato Robotics botvac Schnellstartanleitung

Preparation and Set Up

Remove Films and Stickers
1
IMPORTANT
Remove all protective films and shipping
material from the robot and charge base.
If they are not removed, Neato will not
operate correctly.
Set Up Charge Base
2
Plug the power cord securely into the
charge base.
Adjust the length of the cord by wrapping
it as shown.
Choose a wall outlet that has a 3' (1 m)
clearance on both sides and in front of the
charge base. This helps your robot find the
charge base.
Plug in the power cord and push the charge
base against the wall.
Locate the charge base on a hard floor
Tip:
surface.
Tip: Make sure the power outlet is not
controlled by a switch.
Set Power Switch On
3
IMPORTANT
Open the dirt bin and remove the tab.
OFF
O N
Tab
Push on the switch to power
DOWN
on the robot
Put the dirt bin back in the robot.
5
OFF
ON