Additional Information - Icy Box IB-289U3 Handbuch

www.icybox.de
Set-up password operation
Step 1: Install a new HDD or used HDD without data.
Note! Please backup your data of old HDD firstly. All the data on a used
HDD would be lost after set-up.
Step 2: Keep press buttons "1" and "3" at the same time, then plug the USB
cable into the host of computer, and wait for 10 seconds until blue and red LED
light keep continuous bright.
Step 3: Keep press "Lock" button for 10 seconds until the Orange LED light
keep continuous bright.
Step 4: Enter your password (1~12 digits), then press "Unlock" button to
confirm it.
Step 5: Enter the password again (the same as first time), then press "Unlock"
button to confirm it.
At this time the red LED light goes off, then green LED light bright, it mean
successfully set up password.
Note! Make a note of your password and store it in a safe place to prevent
misuse. It's not possible to restore the HDD if you lost the password.
Step 6: Complete the setting inside Disk management of your system.
Change password operation
Step 1: Keep press "Lock" button, and then connect Encrypted HDD enclosure
to computer by USB cable.
Step 2: Keep press "Lock" button wait for 10 seconds until the red LED and
orange LED bright at the same time, then loosen "Lock" button.
Step 3: Enter existing password, then press "Unlock" button to confirm it, at
this time the orange LED goes off.
Step 4: Enter NEW password, then press "Unlock" button to confirm it.
Step 5: Enter NEW password again, then press "unlock" button to confirm it.
Step 6: At this time, red LED goes off, green LED bright, now it change pass-
word successfully.

Additional Information

• If the password is entered incorrectly more than 99 times, the data
at the installed HDD/SSD are blocked permanently for security rea-
sons and not accessible anymore.
• The unlocked device will automatically change to the encrypted
mode after about 13 minutes of inactivity.
7
IB-289U3