The Sonyset Table - Bosch MIC440 Installationshandbuch

MIC440 Explosion Protected CCTV Camera System| Installation and Operation Manual

The SonySet Table

The table on the right of the form indicates the current state of one of the presets.
The first column Sony Command indicates the command type for each of the 10
steps in each preset. The Option column indicates the current value for the chosen
command, (e.g On or Off) or if the command is a direct set type, this will indicate
the range available and the result is displayed in column 3, Value.
A full list of available commands and values is shown below.
Changing any of the Sony Commands will invoke the corresponding Option to also
change and take on the top value in the list of available options, therefore clearing
the previous setting from memory. If the command type requires a numeric input,
the corresponding Value box will indicate the lower bound of the range, which can
then be changed to any valid value.
Bosch Security Systems
If only a few commands are utilised on the list then the rest should be set to "End"
which will display "N/A" in the option column.
Below is a list of the available SonySet Commands and their corresponding Values
or valid value ranges:
Table M – Sonyset Commands
Command
Camera Power
Zoom Set
Digital Zoom
Focus Set
Focus Mode
Focus Control
AF Sensitivity
Focus Near Limit
White Balance Mode
White Balance Control
Red Gain Control
Red Gain Set
Blue Gain Control
Blue Gain Set
Exposure Mode
Slow Shutter Mode
Shutter Control
Shutter Set
Iris Control
Iris Set
Issue 7
EN | 45
Value
On / Off
0 to 28672
On / Off
4096 to 49152
Auto / Manual
One Push Trigger / Force Infinity
High / Low
4096 to 49152
Auto / Indoor / Outdoor / One Push /
Auto Tracing / Manual
One Push Trigger
Reset / Plus 1 / Minus 1
0 to 255
Reset / Plus 1 / Minus 1
0 to 255
Auto / Manual / Shutter Priority / Iris
Priority / Gain Priority / Bright / Shutter
Auto / Iris Auto / Gain Auto
Auto / Manual
Reset / Plus 1 / Minus 1
0 to 19
Reset / Plus 1 / Minus 1
0 to 19