Troubleshooting - Hurricane r39090 Bedienungsanleitung

Turn the steering wheel right to turn the front tires go right. Turn
the steering wheel left to turn the front tires go left.
feaTures mamBa monsTer sysTem
1. Specially designed for RC car RTR (Ready To Run) application.
2. Excellent start-up, acceleration and linearity features.
3. Compatible with sensorless brushless motor.
4. Running modes: Forward mode (single direction) and Forward/Backward mode (dual directions)
5. Proportional ABS brake function, with 4 steps of maximum brake force adjustment, 5 steps of drag-brake force adjustment.
6. Different options of start modes (also called "Punch") from "soft" to "aggressive".
7. Multible protection features: Low voltage cut-off protection for lithium or nickel battery / Over-heat protection / Throttle signal loss pro-
tection / Motor blocked protection.
8. Splash proof and dustproof.
2200kv motor combo
Max Input Volts 25.2
Amp Rating 120
Weight 424g (15oz)
Motor Diameter 39.98mm 41.78mm with fins
Motor Length 75.18mm
Shaft 5mm
Bearings Oversize ABEC-1 front and rear
Connector 6.5mm
Trouble shooting
Touble
After power on, motor doesn't work,
and the cooling fan doesn't work
After power on, motor can't work, but
emits "beep-beep-, beep-beep-" alert
tone. (Every group of "beep-beep-"
has a time interval of 1sec.)
After power on, red LED always lights,
the motor doesn't work
The motor runs in the opposite direc-
tion when it is accelerated
The motor suddenly stops running
When accelerating quickly, the motor
stops or trembles
Possible Reason
The connections between battery pack and ESC are not
correct
Input voltage is abnormal, too high or too low
Throttle signal is abnormal
The wire connections between ESC and the motor are not
correct
The throttle signal is lost
The ESC has entered the Low Voltage Protection Mode or
Over-heat Protection Mode
1) The battery performs bad under high currents (too low C-rating)
2) The gear ratio is too low (e.g. pinion gear with too many teeth)
3) "Start Mode" (punch) is set too aggressively on the ESC
Press the throttle trigger to moving forward the vehicle.
Push forward the throttle trigger to brake and reverse the vehicle.
mamba monster esc
Cells 4s-6s LiPo
Continuous 120A
Resistance 0.0003 ohms per phase
Brake Proportional with adjustable
curve
Reversible Yes - with lockout
Low Voltage Cutoff Programmable
Size 2.2" x 1.9" x 1.4"
Weight w/wires 121g (4.26 oz)
Connector 6.5mm bullet
Solution
Check the power connections
Replace the connectors
Check the voltage of the battery pack
Plug the control wire into the throttle channel of the receiver
correctly
Swap any two wire connections between the ESC and the motor
Check the transmitter and the receiver.
Check the signal wire from the throttle channel of your receiver
Red LED flashing means Low voltage protection. Please replace
battery pack. Green LED flashing means Over-heat protection, please
stop running to cool the ESC.
1) Use better batteries.
2) Use a smaller pinion on the motor.
3) Set "Start Mode" (punch) to a lower value.
hurricAnE
5