Required Tools - Hurricane r39090 Bedienungsanleitung

hurricAnE
Thank you for purchasing a Robitronic product.
General BuildinG Tips:
` Please carefully read the instruction manual, safety precautions and warranty provisions before you start assembling and operating this model.
` Make sure that the ESC's wires are firmly plugged into the reciever.
` Clear a work area and try to work on a light color towel to avoid missing dropped parts.
` Don't over-tighten fasteners. Many assembly problems are caused by over-tightening screws or nuts. Don't use too large a grip. Please
go slowly and feel restance build. Just snug it up.
` When it doesn't fit, please double check. If an assembly isn't going together correctly, then either there really is a bad fit (e.g. a part is
damaged or defective) or a mistake in assembly. Always re-read the instruction when there are any problems. If you cannot figure out
what's wrong, always ask dealer, and distributor. Don't use force beyond what the instructions call for.
` Using the right tools makes assembly much easier. The instructions below finely indicate you what to get to make things easier. We
don't want to scare you by saing that all these tools are required, but you will have a easier time if you have them. Borrow them from a
friend to check if necessary.
included Tools
Cross Wrench
(17mm)
Helpful equipmenT
AA Alkaline or rechargeable batteries for
transmitter, 8pcs.
8 x AA2000EN oder 1 x R05101

required Tools

Hobby knife
Sniper Tool Sniper Tool
Metric Size Metric Size 3.0mm
1.5mm / 2.0mm / 2.5mm RS618
RS611, RS612, RS613
2
Battery Pack Charger
e.g. R01004 Expert LD15z or R01005 Expert LD 16z
Body Scissors, R06207
(for body cutting)
Sniper Tool
Metric Size 5.5mm
(for 3mm nut)
RS601
2 x 2S (7,4 V) or
2 x 3S (11,1 V) Lipo Pack
Needlenose Pliers