Connecting External Devices; Connecting Passive Or Active Speakers - TerraTec Maestro 3296 Handbuch

Connecting External Devices

Speakers or headphones, a CD-ROM drive, a MIDI keyboard, a mono-microphone, a joystick
and two external audio devices (stereo-microphone, cassette recorder, CD player, tuner, mixer,
etc. ...) can be connected to the soundcard. An external Wavetable module which meets the
Creative Labs Waveblaster standard can also be used in addition to the internal Wavetable.

Connecting passive or active speakers

The output of the soundcard is suitable for connecting passive speakers/headphones or active
speakers/stereo systems. It is designated as „Out", and can be adjusted to suit your playback
devices by means of the installation software and the mixer control. The 2x4 Watt amplifier on
the card is adequate for operating headphones or a pair of small passive speakers. If you wish
to connect a stereo system, connect the output of your soundcard to the AUX input of your
stereo system. The amplifier must also be switched off if you connect active speakers (with a
built-in amplifier).See also chapter "The Mixer Panel, under DOS".
Amplifier
Audio output (stereo)
PJ1
On/Off
Audio LINE-input (stereo)
PJ2
PJ3 Audio MIC/LINE-input (stereo)
PJ4
Microphone input (mono)
Port for joysticks
and external MIDI-devices
via MIDI-Kit
(p)´96 ...oli!
Connection for external devices
61