Descaling; Maintenance And Cleaning - Fakir MARTHA Benutzerhandbuch

• The heater base is located just below the water heater body, and the water heater
body sits properly on the tank.
• Plug in the appliance.
• Turn the on/off switch to the opening position (I), the light aligned to direction of the
water level indicator will flash and the water inside the appliance will start heating.
• When the water in the appliance boils, the light will turn off automatically when the on/
off button is turned off. The on/off button may be used to stop the water heating of the
appliance in each cycle of water heating.
• You can transfer the hot water to any other container of your choice.
• The appliance has a safety protection circuit against waterless operation. In the event
of waterless operation, the appliance will automatically turn off the heating elements.
In such a case, unplug the appliance from the outlet. After allowing the water heater
for 15-20 seconds, you can refill it with water.
CAUTION!
The amount of water you put into the appliance must never exceed the MAX level.
Otherwise, the water may overflow.
CAUTION!
If you tilt your appliance backwards more than 30°, some water may spill. For this
reason, do not tilt the appliance backwards with water in it.

Descaling

If the appliance turns off automatically before reaching the boiling point, it is a sign that
it should be descaled.
Add 1/3 vinegar and 2/3 water mixture into the appliance. Pour after boiling 2 or 3 times.
After performing the descaling process, boil the appliance 1-2 times with clean water
and rinse. Then drain away the boiling water.

Maintenance and Cleaning

Before cleaning the appliance, make sure that it is unplugged and the appliance is
cooled down completely.
Do not use hard or abrasive detergents to clean the appliance.
Do not allow the heater body or the heater base to contact with water. Clean the inside
and outside of your appliance with a soft damp cloth.
We recommend that the appliance is cleaned regularly.
WARNING!
Do not use benzene, solvents, abrasive cleaners, metal objects or hard brushes to
clean the appliance.
19
EN