Maintenance - Patron JACKO Gebrauchsanweisung

 K opravám mohou být použity jen originální náhradní díly dodávané
výrobcem.
 Rotační a posuvné části kočárku pravidelně ošetřujte mazadly ve spreji
(např. WD 40), minimálně každých šest měsíců. Nikdy nepoužívejte olej
nebo vazelínu. Dbejte na to, abyste nepoužili příliš velké množství
mazadla (způsobilo by to zanášení špíny mezi otáčející se části). Přeby-
tečné mazadlo otřete.
 Skládání a rozkládání kočárku by vždy mělo být velmi lehké. Pokud
tomu tak není, přečtěte si znovu příslušné odstavce v návodu k použití.
 Kontrolujte pravidelně tlak v pneumatikách.
 Podvozek, plasty a kolečka je možné omývat teplou vodou s přídavkem
běžného saponátu.
 Potah kočárku lze čistit hadrem namočeným v teplé vodě, případně
vyprat v ruce (max. 40°C)
 Nikdy kočárek nečistěte abrazivními čistícími prostředky, prostředky na
bázi amoniaku, bělidly a lihovými čistidly.
 V případě, že byl kočárek vystaven vlhkému prostředí, utřete ho savým
materiálem a nechte v teple uschnout.
 Kočárek ukládejte na suchém a bezprašném místě při doporučené teplotě
5-20°C.
 Pravidelně kontrolujte a dotahujte šroubové spoje.
 Doporučujeme po 24 měsících navštívit servisní oddělení.
 Jsou-li použita ovládací lanka (brzdy, teleskopy, naklápění), pravidelně
je kontrolujte a v případě potřeby seřiďte a promažte.
POZNÁMKA
Změny na všech výrobcích společnosti PATRON Bohemia a.s. jsou vyhra-
zeny.
SCHEMA - POPIS:
1. Vodítko
2. Kloub vodítka
3. Uzávěr vodítka
4. Opěra zad
5. Úchyt stříšky
6. Úchyty hrazdičky
7. Podnožka
8. Přední kolo otočné
9. Aretace předního kola
10. Zadní kolo pevné
11. Brzda zadního kola
12. Košík
13. Imbus.šrouby pro nastavení úhlu stupačky
14. Suchý zip zajištění stupačky
15. Stupačka
16. Boční chránič rámu
17. Transportní pojistka
12
 When the stroller is folded and unfolded, the user guide must be followed carefully, to avoid any damage on the construction what could affect the
product stability.
 In case of apparent defect, which limits product's safe using (e.g. damage of chassis, part falls away or other optically visible defects, cracks etc.) it is
necessary to stop using the product immediately and contact your local official distributor or service centre.
 Company PATRON does not bear any responsibility for the damages caused by using other than original PATRON accessories supplied by this compa-
ny.
INTRUCTIONS FOR USE
1) Chassis:
Assembling the stroller (with attached seat):
Place folded stroller on wheels. Unbutton and release the transport safety-
catch on frame(17). To open the undercarriage stay between the rear wheels
and hold handle tightly. Move handle up and backwards until the handle
folding release is fully locked in its end position (3). To check the locking
position, move upwards the handle to ensure that both mechanism are fully
locked (the undercarriage must not start folding). Pull the padded frame
covers downwards over the locking mechanism and close both covers by
zippers properly .Release backrest recline adjustment lever (18) and set the
position of backrest. Tighten lever properly. Release the footrest angle
adjustment lever, set the position of footrest and tighten lever again. Unfold
the footplate and lock it by velcro fastener. Attach the safety bar. Attach and
adjust fixation accessories if needed. The stroller is assembled.
Folding the stroller (with attached seat):
Apply the parking brake and take off the safety bar. Press both buttons on
footrest hinge simultaneously and set the position of footrest a bit less than
horizontally ca 20 degrees. Release the footrest velcro lock and close the
footplate. Release the backrest recline adjustment lever and push backrest as
far as possible forward, towards the seat base. (It is recommended to take
out the exceeding fixing accessories and adjust the seat width by side plates
to the maximum limit, which enables to decrease the size of the folded
seat). Tighten the lever. Unzip the padded frame covers partially and pull
over the locking mechanism upwards. Lift the handle folding release
movable parts on both sides and fold the handle forward towards the front
wheels. Ensure folded undercarriage by transport safety-catch. The stroller
is folded
Parking Brake:
To engage the brake, press brake lever pad on both sides fully till the end
position. To disengage the parking brake, lift both brake lever pads.
Swivel lock:
If needed, the front wheel forks can be locked against vertical rotation. To
lock the castor forks lift and turn the swivel lock pin by 90° on both sides
and let it to snap in in the designated hole on the castor fork.
Handle height adjustment:
To change the handle height position press the black plastic buttons on the
handle hinges on both sides simultaneously (2), set the handle to desired
position, release buttons. Handle will lock in new position automatically,
you will hear the locking sound.
Safety Bar:
To take off the safety bar press pin release on both sides simultaneously and
pull the bar upwards to remove it. To insert the safety bar, both pin releases
have to be pointed ahead. Press slightly both press pins and insert the safety
bar into the tube inlays at once until the pins are locked. Check the correct
position of safety bar by slight pulling up, safety bar must not lift.
Backrest recline positioning:
Hold the seat backrest firmly. Loose backrest recline adjustment lever (18).
Set the position of backrest. Tighten the lever properly. If needed unzip
partially the zipper placed on the rear part of backrest cover to make the
manipulation easier. Check the correct locking of the backrest position.
Backrest must stay in preset position.
Footrest set angle positioning:
Press both buttons on footrest hinge simultaneously (13), set the angle
position of footrest and release the buttons. Footrest will be locked in the
new position automatically, you will hear the locking sound.
Footrest-set height positioning:
Loosen two hexagon-bolts placed on rear side of footrest slider profile. Set
desired position of footrest. Properly tighten both hexagon-bolts.
Footplate angle adjustment:
Loosen two hexagon-bolts placed under the footplates. Set the angle of
footplate by pulling or pushing of footplate angle adjustment slide-plate,
which is determine requested angle of the footplate. Properly tighten both
hexagon-bolts.
Footplate velcro lock:
Tighten and fasten at any time the velcro lock fastener placed under the
footplate to ensure fixed footrest position. (security device against folding
of footplate).
Standard equipment
Basket below the stroller :
Attaching – Attach the baskets centre part over the undercarriage middle
cross bar using fasteners. Fix it with the poppers. Attach the baskets rear
part, interlace the fasteners through the side loops placed on the rear frame
profiles. Fix it with the poppers. Attach the baskets front part over the
undercarriage front curved cross bar using fasteners. Fix it with the pop-
pers .
Detaching – unfasten and release all fasteners from the anchoring points.
Transport safety catch:
Attaching – pull the transport safety catch fastener around the connecting
bar and front frame vertical tube. Interlace the fastener through the loop and
fix it with the popper.
Detaching – unfasten and release the fastener.
Optional equipment:
This product can be optionally supplied with very wide range of fixation
and positional accessory. Please find the optional accessory user guide as
separate brochure.
2) Stroller in operation:
Getting into the stroller:
Engage parking brake. If necessary ask trustful person for help to hold the
stroller firmly. Place the child into the stroller carefully. Attach the safety
bar and adjust the footrest position. Pull on and adjust all fixation and
positioning accessories the stroller is equipped with. Always make sure that
the child is seated comfortable in the stroller.
Getting out of the stroller:
Engage parking brake. If necessary ask trustful person for help to hold the
stroller firmly. If required to easy getting out of the stroller adjust footrest
position Take off all applied fixation and positioning accessories. Take off
the safety bar and get the child carefully out of the stroller.
Getting over the curb stones and low obstacles:
Down - Drive the front wheels to the edge of the curb. Hold the handles
firmly and tip the stroller backwards and balance on the rear wheels. Drive
the rear wheels to the edge of the curb, lower the stroller down the curb
slowly on its rear wheels.
Up - Drive the front wheels close to the curb. NEVER bump the front
wheels into the curb stone!. Hold the handles firmly and tip the stroller
backwards and balance on the rear wheels. Drive forward and place the
front wheels on top of the kerb. Position the rear wheels at the curb tone
bottom edge and lift to the upper level.
Manual transport of the stroller:
- make use of ramps and lifts when they are available
- if there is no alternative and steps should not be avoided at least one
trustful assisting person must be available to give assistance
- do not attempt to take the stroller up or down over the number of steps
unless you and your assisting person are not sure to have the full control
during the manipulation as well as he or she can absorb the weight of its
occupant and stroller.
- take the rests in regular intervals, if you are tired
- occupant hands must be inside the seat unit during the manual transport
time
- NEVER lift the stroller holding the safety bar or footrest!
Going stairs downwards:
Tightly hold the handle and position the stroller squarely with the front
wheels on the top step. Tip the handle backward and push the stroller
forward until the rear wheels are at the end of top step. Assisting person
stands in front, holding the stroller by gripping the front frame. Lift the
stroller by both persons at once. Carry the stroller down the steps. Continue
step by step to the bottom surface.
Going stairs upwards:
Tightly hold the handle and position the stroller squarely with the rear
wheels against the bottom step. Tip the handle backward and push the
stroller forward until the rear wheels are at the end of bottom step. Assisting
person stands in front of stroller, holding the stroller by gripping the front
frame. Lift the stroller by both persons at once. Carry the stroller upstairs.
Continue step by step to the top surface.
Upholstery:
Seat upholstery is fully detachable and hand washable by lower temperature
(max. 40°C).
Unzip the zipper of the upholstery on the back side of backrest. Pull the
upholstery over the top of the backrest and attach to the backrest and seat by
Velcro fasteners. Pull the upholstery over the seat side panels one by one.
Fasten the zipper of backrest upholstery.

MAINTENANCE

The stroller has been designed to the high standard and with correct usage
and maintenance will provide you many years of trouble free service.
5