Setting The Temperature; Ironing With Steam - Bosch Sensixx DS37 Gebrauchsanleitung

Important:
▪
Normal tap water can be used. To prolong
the optimum steam function, mix tap water
with distilled water 1:1. If the tap water in your
district is very hard, mix tap water with distilled
water 1:2.
▪
You can inquire about the water hardness with
your local water supplier.
▪
The water tank can be illed at any time while
using the appliance.
▪
To avoid damage and/or contamination of the
water tank and the boiler, do not put perfume,
vinegar, starch, descaling agents, additives
or any other type of chemical product into the
water tank.
Any damage caused by the use of the
aforementioned products, will make the
guarantee void.
▪
The iron is not designed to rest on its heal.
Please always position it horizontally on the
iron pad (2).
▪
The iron pad can be placed into the specially
designed recess on the appliance or
somewhere suitable alongside the ironing area.
Never rest the iron on the appliance without
the iron pad!
▪
During its irst use the iron may produce certain
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes.
▪
While the steam release button is pressed, the
water tank may produce a pumping sound,
this is normal, indicating that water is being
pumped to the steam tank.
Setting the
temperature
1. Check the ironing instruction label on the
garment to determine the correct ironing
temperature.
2. Turn the temperature selector (12) to the
required setting:
•
Synthetics
••
Silk – Wool
•••
Cotton – Linen
3. The indicator lamp (15) will remain lit while the
iron is heating and go out as soon as the iron
has reached the selected temperature.
Tips:
▪
Sort your garments out based on their cleaning
symbol labels, always starting with clothes that
have to be ironed at the lowest temperatures.
▪
If you are not sure what the garment is made
of then begin ironing at a low temperature and
16
B OS CH
decide on the correct temperature by ironing a
small section not usually seen when worn.
2
Ironing with steam
The steam control is used to adjust the
amount of steam produced when ironing.
1. Turn the temperature selector (12) to the
required setting.
2. Set the amount of steam to suit your
needs, using the variable steam control (5*)
(depending on the model).
For normal use, please choose one of the
following recommended settings:
Temperature
•
••
•••
3. Press the steam release button (13-14*) to
release steam.
Attention:
When ironing on a lower temperature setting "•".
▪
If the appliance has variable steam control
(5*), set the variable steam control to its lowest
position .
▪
If the appliance does not have variable steam
control, press the steam release button only for
a few seconds at a time when ironing at lower
temperatures.
In both cases, if you ind that water is dripping out
of the soleplate, set the temperature selector (12)
to a higher position (take care that the garment
can be ironed on this heat temperature
setting).
▪
At the beginning of each use, it is possible that
drops of water will be dispensed alongside
steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
Tip : for better ironing results, iron the last
strokes without steam to dry the garment.
"PulseSteam"
function
(Model dependent)
This appliance has a special function for tackling
dificult creases.
The "PulseSteam" function helps soften stubborn
garments like jeans or linen faster.
When the steam release button is activated, the
steam generator will release three powerful shots
Steam setting