Ikra PCS 3835 Gebrauchsanweisung Wartung Und Pflege Seite 31

Logging and limbing
WARNING
1. Always ensure your foothold as well as stability of
the tree.
2. Be alert to the rolling over of a cut log.
3. Read the instructions in "For Safe Operation" to avo-
id kickback of the saw.
Before starting work, check the direction of bending force
inside the log to be cut.
Always finish cutting from the opposite side of bending
direction to prevent the guide bar from being caught in
the cutaway.
Cutting an unpillowed log
Saw down halfway, then roll the log over and cut from
the opposite side.
Cutting a pillowed log
In the area A in the picture right above, saw up from the
bottom one-third and finish by sawing down from the top.
In the area B, saw down from the top one-third and finish
by sawing up from the bottom.
Limbing a felled tree
First check which way the limb is bent. Then make a
shallow cut into the compressed side to prevent the limb
from being torn. Cut through from the tensed side.
WARNING
Be alert to the spring back of a cut limb.
GB | Operating Instructions
Pruning
Cut up from the bottom, finish down from the top.
1. Do not use an unstable foothold or a stepladder.
2. Do not overreach.
3. Do not cut above shoulder height.
4. Always use both hands to grip the saw.
1. Do not use an unstable foothold or a stepladder.
2. Do not overreach.
3. Do not cut above shoulder height.
4. Always use both hands to grip the saw.
The Spiked bumper must always be put on while using
the chain saw on tree trunk. Push the spiked bumper
into the tree trunk by using the rear handle. Push the
front handle in the direction of cutting line. The spiked
bumper must be remaining set for further saw guiding if
necessary. Use a spiked bumper when cutting trees and
thick branches can ensure your safety and decrease the
working strength and vibration level.
12
WARNING
WARNING
WARNING