Santec SNC-6332 Kurzanleitung Seite 2

Kurzanleitung / Quick installation guide
SNC-6332
To operate the panorama camera, please follow these steps:
1. Install the camera in the desired
location.
2. Connect the camera to power using
a suitable power adapter
(12 V DC) or via PoE (PoE switch
or PoE injector required).
3. Connect the camera to the network
using a LAN cable. The network LED lights up in orange.
4. Insert the CD (included in the delivery) into your PC/laptop and install the IP-finder.
5. The IP-finder displays an IP address for the camera. Double-click on the IP address
and the Internet Explorer comes up automatically. In case this doesn't work, you may
also enter the IP address (as shown by the IP-finder) manually into the Internet
Explorer. Using the IP-finder, another IP address can be assigned to the camera, if
required.
Note:
The camera comes with a default IP address:
Default IP address:
User name:
Pass word:
Please refer to the user manual for further information on camera configurations.
Subject to technical changes. Errors excepted.
QUICK INSTALLATION GUIDE
IP panorama camera SNC-6332
192.168.1.168 (or DHCP, if available)
admin
9999
Audio Out
RJ-45
Audio In
Micro SD
12 V DC
GPIO
1. Prepare a PC/laptop with an Ethernet
link to the network.
2. Connect the LAN port (RJ45) of the
camera to a network switch/hub.
No. 3 and 4 are not necessary if
PoE is used.
3. Plug-in the power jack.
4. Connect the 12 V DC adapter
to power.
5. Check the network LED status.
Version 1.0sfi/0212/dt-engl/A5
Lens adjustment