Inhaltsverzeichnis
Werbung
Anschlussbild
CO
S
S
AFETY
YSTEM
2
What to do in case of an ALARM?
1. Keep calm!
2. Turn off the acoustic alarm by pressing the RESET button on the bottom side.
3. Investigate the type of alarm and which sensor is giving the alarm by
following the instructions below.
INDICATION
CAUSE
ACTION
!
- The red diode ON.
MAIN ALARM
- DO NOT ENTER the dangerous area.
- Continuous acoustic signal.
- Ensure, to the extent possible, that
there is ventilation from the outside.
Display!
- Call and inform the following telephone no:
1. ALARM, Sensor number and CO
2
%.
2. This is shown 3 times each cycle.
Note!
.............................................................................
To reset the system, press the reset
button until 2 signals sound.
- When the CO
2
level has fallen,
TAKE PRECAUTIONS
correct the cause, as described
Online is shown in display.
in the LOW-ALARM below.
- The red diode ON.
LOW-ALARM
- Enter the room in question ONLY under
- Intermittent acoustic signal.
the supervision of another person.
- Open the doors and the windows as
Display!
much as possible.
1. LOW-ALARM, Sensor number
- Close all CO
containers.
and CO
%.
2
2
2. This is shown 3 times each cycle.
- Remedy leakage.
Note!
To reset the system, press the reset
button until 2 signals sound.
Online is shown in display.
- The yellow diode ON.
SYSTEM FAULT
- Check the manual.
- Intermittent acoustic signal.
Display!
Fault no, Sensor no and fault code.
Note!
To reset the system, press the reset
button until 2 signals sound.
Online is shown in display.
Sensor
Place
1
2
3
4
5 m
2 m
Kabelverlängerungsstück
Plug-lock
10 m
2 m
Schneiden Sie die Verriegelungslaschen an den
RJ45-Steckern ab, um sicher zu stellen, dass die
Anschlussverbindung des CO2-Sicherheitssystems
nicht von Unbefugten gelöst werden kann.
9
Anschlussbilder IV
15 m
1 m
Werbung
Inhaltsverzeichnis
