Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switch receiver on.
Wait for about 10 seconds
Take off the jumper
Your Fail-Safe system is now set up.
Testing the Fail-Safe function
Switch on transmitter
Switch on receiver
Check functions and assignments of all servos (direction, correct channel?)
Move all control sticks into any position and switch off the transmitter. Initially all servos should stay at their last positi-
ons. After about 2 seconds they should move into the pre-programmed positions.
If this does not happen, please repeat the programming procedure.
ATTENTION: Never disconnect the transmitter nor the receiver from its current supply during programming!
There will not be any harm done to the system, but you will have to repeat the entire programming procedure.
After having finished programming remove the jumper and install the receiver into you model.
You may connect 8 servos to the receiver. If all connectors are occupied, the receiver power supply can be connected
via a Y-cable.
WARNING: When switching off a computerized transmitter it may take up to 8 seconds until the transmitter reboots
after switching it on again, resulting in an up to 8 second delay to the resumption of the control functions. NEVER
perform the ON/OFF test during flight; it could by your last flight on that day.
One more proposal:
Due to the complexity of the receiver features and the possibility of user programming it is recommended to perform a
pre-flight check to test if all channels as well as the HOLD and Fail-Safe modes are performing as programmed.
Your IKARUS Team is wishing you many happy flying hours and safe landings.
Werbung
