Lexors Silverline OCTAVA Anleitung Seite 5

- Current consumption:
- Connectors:
- Temperature range:
Programming
The standard set up has to be performed before installing the receiver into the model. To start the programming just
plug one of the included jumper connector into channel 2 and any type of servo into channel 1.
All programming begins with the receiver switched off!
Channel output 5 on servo connector 5
Plug second jumper on channel 3
Switch on transmitter
Switch on receiver
Wait till the connected servo moves briefly as a confirmation of the set up
Switch off receiver
Channel output 9 on servo connector 5
Plug second jumper on channel 4
Switch on transmitter
Switch on receiver
Wait till the connected servo moves briefly as a confirmation of the set up
Switch off receiver
Switch off Fail-Safe mode (factory setting)
Plug second jumper on channel 5
Switch on transmitter
Switch on receiver
Wait till the connected servo moves briefly as a confirmation of the set up
Switch off receiver
Switch on Fail Safe mode
Plug second jumper in channel 6
Switch on transmitter
Switch on receiver
Wait till the connected servo moves briefly as a confirmation of the set up
Switch off receiver
Programming of the Fail-Safe positions
Attention: Take off propeller on electric powered model airplanes!
Assuming you have set the Fail-Safe mode to "ON" you may proceed with the next step
The servo factory settings for Fail-Safe are:
Channel 1 and 3: 1msec (this means "OFF" on electric speed controllers) – recommended for safety reasons.
All other channels: 1.5 msec (this means for most transmitters the servo center position)
User programmable Fail-Safe positions:
After installing the receiver in the model, please switch on the transmitter and than the receiver, move the transmitter
sticks and set the servo direction, trimming, servo throw, mixer etc. into the position in which you would like them to
go in case of an interference. Ask someone to hold the transmitter sticks in the selected position while you work on the
programming as follows:
Leave the transmitter switched on
Switch off the receiver.
Plug a jumper into any receiver channel.
11 mA
Lexors, Futaba, Hitec, JR Graupner
-10°C to +40°C (14°F to 110°F)