Range Of Applications And Improper Use; Description Of Safety Symbols - Glomar AS-85 Bedienungsanleitung

AS85

2. Range of applications and improper use

The battery-operated hydraulic tool AS85 is designed to cut aluminium and copper
cables up to a diameter of 85 mm. Do not use the tool for cutting live parts. The tool
does not provide insulation. The battery-operated hydraulic tool must be used in areas
with lighting levels of at least 400 lux or daylight.
The cutting tool has been designed to be used by qualified, suitably trained
■
electricians, who possess the necessary experience.
■ The cutting tool must only be used by persons who have the necessary physical
characteristics, are sufficiently stable and are able to react to sudden unexpected
movements.
The hydraulic cutting tool must be used by one operator only at any one time.
■
Before using, move all persons away from the hazard area.
■
The cutting tool must be used exclusively as a manual tool.
■
■ The tool is not designed for stationary use and must not be locked in position using
locking devices.
The cutting tool is not suitable for cutting live components.
■
Any use not covered in the following chapter shall be considered non-compliant with the
intended use and is therefore not permitted. The indications set out in this instruction
and maintenance manual must be strictly followed.

3. Description of safety symbols

Attention! Don't cut steel
Risk of
cutting injury
l
Glomar AG Seestrasse 11
Never use with
unlocked
workhead
l l
CH-9326 Horn T +41 71 841 70 70
Read the operating Wear protective
instructions
before use
l
www.glomar.ch
goggles
19
19