Cleaning And Care - iCES IBM-500 Bedienungsanleitung

Warning
Do not attempt to start operating the bread maker, before it has either cooled down or
warmed up. If the display shows "HHH" after the programme has been started, it
means that the temperature inside of bread pan is too high. You should stop the
programme and unplugged the power outlet immediately. Then open the lid and let the
machine cool down completely before using again.
If the display shows "LLL" after the programme has been started, it means that the
temperature inside of bread pan is too low. You should place the bread maker on a
higher environment for using.
If the display shows "EE0" after you have pressed "Start/Stop" button, it means the
temperature sensor open circuit, please check the sensor carefully by Authorized
expert. If the display shows "EE1", it means the temperature sensor short circuit.

11.Cleaning and Care

Warning
Pull the power plug out of the wall socket each time and allow the appliance
to cool down. Protect the appliance against splashing water and moisture, as these
could lead to an electric shock. Please also observe the safety instructions.
Important
The parts and accessories of the appliance should not be washed in a dish washing
machine.
Casing, lid, baking chamber
Remove all particles left behind inside the baking area using a wet cloth or a slightly
wet soft sponge. Wipe the casing and the lid too with a wet cloth or sponge. Make sure
that the inside area is fully dry.
Bread pan and kneading paddle
The surfaces of the bread pan and kneading paddle have a non-stick coating. While
cleaning, do not use any abrasive detergents, cleaning powders or objects that may
cause scratches on the surface. Due to moisture and vapor the surface of various
parts may undergo changes in their appearance over a period of time. This does not
affect the quality or functional performance of the appliance. Before cleaning, take the
bread pans and kneading paddles out of the baking area. Wipe the outside of the
bread pans with a damp cloth.
Important
Never immerse the bread pans in water or other liquids. Clean the interior of the bread
pans with warm, soapy water. If the kneading paddles are incrusted and hard to
release, fill the bread pan with hot water for approx. 30 minutes. If the retainer in the
kneading paddle is clogged, you can clean it carefully with a wooden skewer. Do not
use any chemical cleaning agents or thinners to clean the bread maker.
GB-10