Wolf MAMBO EVO Original Bedienungsanleitung Seite 20

Super pad discs 400mm, 20mm
For initial cleaning, #013546, For cleaning strong soiling
For maintenance, #013547, For coarse cleaning and removing soil
For polishing, #013334, For polishing, cleaning and wax coating
8.0 Trouble shooting
Functioning of the electronic speed control:
By turning the control, the target speed can be set from 100 to 400 rpm.
When under extreme load, e.g. when using abrasive gauze on cork with additional weight, the machine
reduces its speed automatically.
The machine switches off automatically in the event of overloading.
The LED flashes in varying intervals.
The machine has been extremely overloaded.
The machine can be restarted after some seconds.
The machine can be restarted when the LED stops flashing.
This indicates that the electronics have cooled and the machine is operational.
The machine can be restarted when the LED stops flashing.
This indicates that the motor has cooled and the machine is operational
To remove load from the machine, detach the additional weight and/or reduce the speed.
Trouble
Machine does not start
Switch-on lever
cannot be actuated
Machine does not start
Machine does not start
08/2010 Schleifmaschine MAMBO EVO, #061804
... Overload:
... Electronics overheated:
...Motor overheated:
Eventual cause
Power supply
Disconnected
blown fuse
defective cable or plug
Safety lever can only be
actuated, if handle not vertical
Machine overloaded
Machine overloaded
Elimination
Have machine
repaired by a qualified
electrician,
resp. change parts
Lower the handle of
the machine
Take off additional weight.
Set down transportation wheels
on the floor. See cap. 5.0,
Adjusting transportation wheels
Tilt the machine over the
transportation wheels.
The plate is unloaded.
Start the machine and lower it
slowly on the floor
20