Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Safety Precautions
This product complies with the requirements of the following
European Community Directives: 2004/108/EC (Electromagnetic
Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking). Overvoltage category II 600V;
pollution degree 2.
CAT I:
For signal level, telecommunication, electronic with
small transient over voltage
CAT II:
For local level, appliances, main wall outlets, portable
equipment
CAT III: Distribution level, fixed installation, with smaller
transient overvoltages than CAT IV.
CAT IV: Units and installations, which are supplied overhead
lines, which are stand in a risk of persuade of a
lightning,
overvoltage-diverter, current use counter.
To ensure safe operation of the equipment and eliminate the
danger of serious injury due to short-circuits (arcing), the
following safety precautions must be observed.
Damages resulting from failure to observe these safety
precautions are exempt from any legal claims whatever.
*
Do not clamp around conductors with voltages equal or
exceeding 600V ACrms
*
To avoid physical injury, measurements on bare conductors
or conductors with cracked or frayed insulator are forbidden
*
Do not use this instrument for high-energy industrial
installation measurement.
*
Check test leads and probes for faulty insulation or bare
wires before connection to the equipment.
i.e.
main-switches
-7-
on
current
input,
Werbung
