OBID ID RW02.10-AD Montage Und Installation Seite 20

®
OBID
1. Select installation place:
The installation should be executed always on a surface as even as possible.
2. Connection:
see chapter 4. Reader-connection
4. Wall installation:
•
Snap in the connection board from the back side into the lower casing (see Fig. 3)
• Screw bottom part of casing to selected surface.
Take care about the mounting direction (⇑ TOP), see chapter:
• Put the casing upper part straight onto its bottom part and snap it in. (see Fig. 4)
Insert the pin board X1 of the Reader electronic carefully in the socket board X3 of the
connection board (1)!
• Screw top of casing to bottom part by using the screw Torx 3x8mm (Torx T10).
• Remove the protection foil from the front part.
Fig. 4 Fitting of the housing cover
Page 20 of 28
X2
X1
Fig. 3 Backside view with the fitted connection board (1)
Installation
(1)
X3
Fig. 5 Opening of the housing cover
ID RW02.10-AD/-B
3. Installation
FEIG ELECTRONIC GmbH