Using The Safety Hood For Grinding Discs - Smartworks 89 07 16 Bedienungsanleitung

Shaft Lock (7)
Safety Hood (1/6)
Inner Flange
Grinding Disc
Outer Flange
For discs up to 3 mm strong install the outer flange with the flat side
to the disc (Fig. 7), for discs stronger than 3 mm install the outer
flange with the stepped side to the disc (Fig. 8).
Fig. 7

Make sure the cutting disc rotates in the direction of rotation (15)
printed on the machine housing.

After installing a disc perform a brief test run. Discs which cause
vibrations and run unround must be replaced immediately.Keep
the disc away from moisture and oil and protect it from either
hitting or severely bumping against any object.

Using the Safety Hood for Grinding Discs (6)

The safety hood should be aligned is such a way that it protects you
from sparks and flying debrie.
1. Unscrew the safety hood locking screw (9) and turn to the
desired position.
2. Tighten the safety hood in this position.
Operation
Fig. 8
34