Safety Notes - Smartworks 89 07 16 Bedienungsanleitung

Please note the included General Safety Notes and the
following safety notes to avoid malfunctions, damage
or physical injury:
 Make sure the voltage corresponds to the type label on the
electric tool.
 Persons with limited physical, sensorial or mental abilities are
not allowed to use the electric tool, unless they are supervised
and briefed by a qualified person.
 This angle grinder can be used as a grinder, and angle
grinder. Please not all safety advice, descriptions and data
supplied with the electric tool. Disregarding these notes may
lead to electric shock, fire and/or serious injury.
 This angle grinder is not suitable for use as sander, with a
wire brush, or as polisher. Using the tool in ways not intended
by the manufacturer is dangerous and can cause injury.
 Do not use attachments not especially designed for this
device and recommended for this device by the manufacturer.
The fact that an attachment can be physically attached to the
tool does not ensure safe operation.
 The maximum allowed speed for an attachment must be at
least as high as the no load speed noted on the electric tool.
Attachments spinning faster than allowed may be destroyed.
 Outside diameter and thickness of the tool bit must corre-
spond to the dimensions stated on your electric tool. Attach-
ments of the wrong size cannot be shielded and controlled
properly.
 Discs, flanges, and other attachments must precisely fit the
spindle of your electric tool. Tool bits which do not precisely fit
the spindle turn irregularly, vibrate and can cause loss of
control.

Safety Notes

9