Assembly; Adjustments; Adjusting The Head Strap, Fig . A; Adjusting The Ear Protectors, Fig . G-I - FLORABEST FFSH 3 A1 Originalbetriebsanleitung

■ Always flip down the visor when wearing the
helmet .
■ It protects you from flying objects .
■ It does not offer protection from splashing liquids,
hot objects, electricity and infrared/UV rays .
■ Do not use the visor in environments with a pre­
dictable risk from hard or sharp flying objects .
■ Wood shavings and their resin can damage the
visor and impair its transparency .

Assembly

♦ Insert the head strap
inner mountings of the helmet
gage (see fig . A) .
♦ Insert the mounts of the ear protectors
the lateral slots on the helmet
into place (see fig . C) .
♦ Attach the visor with the mesh . To do this,
insert the mesh into the screen from below until
it clicks into place .
♦ Now slide the assembled visor
of the ear protectors
♦ Flip the visor forwards (see fig . E) .
♦ Now slide the visor
protectors as far as it can go (see fig . F) .
■ 10 │ GB │ MT
with all 4 tabs into the
until they en­
into
until they click
into the slots
(see fig . D) .
into the slots of the ear

Adjustments

Adjusting the head strap, fig . A

♦ Turn the head strap adjuster
head strap to fit your head .
♦ The headband should fit your head snugly
when you put on the helmet .
♦ Tighten the headband by turning the head strap
adjuster clockwise .
♦ Loosen the headband by turning the head strap
adjuster anticlockwise .
■ The helmet must sit firmly on your head without
exerting uncomfortable pressure .
CAUTION!
►
Always make sure that the helmet is adjusted
correctly when using it .
Adjusting the ear protectors, fig . G–I
You can adjust the height and position of the ear
protectors .
♦ Push down the bracket of the ear protectors
to lock the ear protectors
♦ Slide the ear protectors
them to the required height (see fig . G) .
♦ Turn the ear protectors
required position (see fig . G) .
♦ Flipping the ear protectors
it easier to put them on or take them off .
If this causes the tension to decrease, use the
ear protector adjuster
♦ Slide the ear protector adjuster
"+" to increase the tension (see fig . I) .
♦ Slide the ear protector adjuster
"–" to decrease the tension (see fig . I) .
to adjust the
onto your ears .
up or down to set
to set them to the
outwards makes
to retighten it .
towards the
towards the
FFSH 3 A1