Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Press the lock down to attach and fix the
mount to the surface.
Snap in the monitor to the suction mount.
Adjust the mounting arm to suit your view
angle to the monitor and tighten the two
screws on the mount to fix the position.
To maximize the effectiveness of the suction mount, it is
recommended that the application be performed under the
following conditions:
Surface temperature should be between 21 °C and 38 °C
(70 °F and 100 °F).
Application below 10 °C (50 °F) should be avoided.
Application should not occur in direct sunlight.
Mounting should be protected from exposure to direct sunlight for
a period of 24 hours.
Note: Under extreme bright light conditions the screen image
may take a few seconds to stabilize. Please wait until the image
has stabilized before backing up.
Monitor Power Connection
1. Insert the small 12 Volt DC plug of the power cable into
the Power jack (12) at the right side of the monitor.
Using
17
Werbung
Inhaltsverzeichnis
