Yamaha MusicCast MCX-SP10 Bedienungsanleitung Seite 4

Before making connections, make sure that the MCX-A10 is switched off.
I Connections
• Connect the push-type input terminals at the rear
of the speakers to the SPEAKER OUT terminals
of the MCX-A10 with the speaker cable provided.
• Connect the (+) terminals on the MCX-A10 and
the speakers using one side of the cable. Connect
the (–) terminals on both components using the
other side of the cable.
• Connect one speaker to the left (marked L)
terminals of your MCX-A10, and the other
speaker to the right (marked R) terminals, making
sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the
sound will be unnatural and lack bass.
MCX-SP10
(Right)
Cautions
• This speaker is specifically designed for use with the MCX-A10. If you connect it to any other component, take care not to
damage the speaker by exceeding its rated input.
• Do not let the bare speaker wires touch each other as this could damage the speaker or the MCX-A10, or both of them.
CONNECTING TO YOUR MCX-A10
Black
I How to connect
1.
Press and hold the terminal's tab.
2.
Remove the insulation coating at the
extremity of each speaker cable by
twisting the coating off.
3.
Insert the bare wire.
4.
Release the tab to allow it to lock
securely on the cable's wire end.
Red
Gray line
MCX-SP10
3
(Left)
MCX-A10