grabner ADVENTURE Eignerhandbuch Seite 19

RUDDER
► ►
Drill the holes at the positions marked on
the stern mount strake, using a drill bit
8.5 mm (not supplied).
► ►
Place the rudder hinge over the stern
mount strake and tension the two wing
nuts.
► ►
Insert the rudder into the rudder hinge
and secure it with the retaining ring.
With the SPEED the rudder attaches to
the transom.
► ►
Fasten the rudder assembly with both
wing nuts in-situ direct to the transom.
RIGGING
► ►
Slot the 3 mast sections together, they
must click into place.
► ►
Feed the main-halyard end without the
carbine over the mast top pulley wheels,
from the rear.
► ►
Insert the mast head fly from above into
the 2 holes of the bracket at the top of the
upper mast element.
► ►
Feed the jib-halyard
wheel of the upper mast element.
► ►
Attach both shrouds to the eyes at the
side on the lower section of the upper
mast element.
► ►
Erect the mast and feed it through the
hole of the fixing frame top panel, and
place it over the stub on the base plate.
over the pulley
19