Control Reference Guide - Technics SE-R1 Bedienungsanleitung

Control reference guide

This unit
∫ Front
  
1 Unit on/off button [
Use this button to turn the unit on and off.
[ ] (off): The unit is off.
[ ] (on): The unit is on.
≥ The unit is still using a small amount of power in off mode. Off
mode uses less power. (
2 Power indicator
The colour of the indicator changes according to the
status of this unit.
Blue The unit is on.
The unit is in standby mode.
≥ To turn on this unit from standby mode,
Red
press the unit on/off button on this unit to
the [
to the [
3 Peak power meter
Display the output level.
4 LAPC indicator ( 13)
5 [DIMMER]
Adjust the brightness of the light and the indicators.
Each press of this button switches the brightness.
6 [LAPC] ( 13)
Measure the characteristics of the amplifier and correct
its output.
≥ The function does not work when the speaker selector knob is
set to [OFF].
7 Input selector knob (
Select the input source or gain value.
8 Speaker selector knob (
Select the output speakers.
    
]
15)
] position, and press it again
] position.
13)
13)
∫ Rear
   
9 Speaker terminals [SPEAKERS] (
: Analogue audio input terminal [UNBALANCED] (
; Analogue audio input terminal [BALANCED] (
< Analogue audio input selector switch (
Switch the analogue audio input.
≥ This switch does not work when the input selector knob is set
to [DIGITAL].
= System terminal [Technics Digital Link IN] (
> Auto off switch [AUTO OFF]
Turn on/off auto off function.
≥ Auto off function:
This unit is designed to conserve its power consumption and
save energy. The unit will turn to standby mode automatically
if there is no sound and it is not being used for approximately
20 minutes.
– To cancel this function, set to [OFF].
? Product identification marking
The model number is indicated.
@ AC IN terminal [AC IN T] (

  
8)
11)
11)
10)
12)
11)
7
(7)