Werbung
Activate and de-activation of the wireless socket-outlet / Aktivierung und Deaktivierung der
Funksteckdose/ Activation et la désactivation de la prise radiocommandé / Activación y
desactivación de la toma de corriente / Attivazione e disattivazione della le presa
telecomandata:
Connect Wireless socket-outlet with remote-controller:
For this press and hold the learning switch (Item 4) for 3 sec. (by pressing and releasing you hear a click).
After that, the LED begins to flash and is now in connection mode. (The LED may only flash after
releasing the learning switch. If the LED already flashing during the pressure, the wireless socket-outlet is
not in connect mode)Take now the remote controller and press one of four left keys (see Item 2) which
you want to assign to this wireless socket-outlet. The wireless outlet-socket is connected now with the
selected letter. For the connection of the remaining wireless socket-outlets repeat the connection process
for each wireless socket-outlet. You can assign each wireless socket-outlet a private letter, but also
several wireless socket-outlet the same letter.
Activation and de-activation WITH remote controller:
After the wireless socket-outlet are connected with the remote controller, you can activated by pressure of
the respective desired letter in the "ON" series (controlling light of the activated wireless socket-outlet
shines permanently). The wireless socket-outlet can be deactivated by pressure of the letter in the "OFF"
series (controlling light of the radio outlet goes out).
Activate and de-activation WITHOUT remote controller:
Activate the wireless socket-outlet by briefly pressing the learning switch (see Item 4). The control light of
the wireless socket-outlet shines permanently red and is activated. By repeat pressing the wireless outlet-
socket is deactivated and the control light turns off.
To cancel connection with remote controller:
Press and hold the learning switch (Item 4) for 6 sec. (by pressing and releasing you hear a click). While
still holding down the learning switch, the LED will begin to flash. After releasing the learning button, press
again briefly the learning switch. Now the connection is removed and you can create a new connection
with a different or the same letters.
SEBSON - Sebastian Sonntag - Gernotstr.17 - 44319 Dortmund Germany - www.sebson.de
4
Werbung
