Operation; Lifting Capacity; Maintenance - Pressalit R8763 Gebrauchs- Und Pflegeanleitung

NURSING TABLE
- USER AND MAINTENANCE GUIDE

Operation:

The height of the nursing table can be adjusted using
the buttons on the wired hand control (A) which clea-
rly indicate "Up" and "Down". Press the button until
the table is in the desired position. As soon as the
button is released, the table will immediately stop
moving.
Safety:
If the safety tray (B) comes into contact with an ob-
ject when the table is being lowered, the motor stops
immediately and the table will rise 3-4 cm to reduce
the risk of pinching/compression injuries under the
table. The table can be used again as soon as the
obstruction has been removed.
Be careful of the risk of being pinched or caught
when the nursing table is being raised or lowered.
Children must not be allowed to
operate the table (C).

Lifting capacity:

The nursing table can take a maximum load of 75 kg.
Cleaning:
The nursing table and the wired hand control may be
cleaned using ordinary cleaning agents which do not
contain solvents.

Maintenance:

Pressalit Care recommends that the nursing table is
fully raised and lowered about once a week (D) to
ensure that all moving parts remain well lubricated.
Resetting the nursing table:
To ensure reliable operation of the nursing table, it
is a good idea to reset it once a week. If the nursing
table is jammed, first try to reset it to get it to move
again. If this does not work, please call your local
Pressalit supplier for service.
1. The nursing table must be lowered all the way
down to its starting position to activate the reset
function. Please make sure that the safety tray is
A
B
C
D
3