Connection And Placing Into Operation - DynaVox E-SA18 Bedienungsanleitung

E-SA18_A6_quer 2013_Layout 1 03.06.13 10:08 Seite 36

CONNECTION AND PLACING INTO OPERATION

Make the cable connections in the order specified
below. Never make changes to the cable connecti-
ons while the devices are switched on! Mechanically
identical RCA plugs are available for input and out-
put connections. Make sure that you do not get
these connections confused during installation!
Make sure that you do not mix up the analogue
inputs for right and left. The RCA plugs for these are
frequently colour coded as follows: red for the right
channel, black or white for the left channel. Make
sure that all plugs fit tightly. Inadequate connecti-
ons can cause noise interference, failures and mal-
functions.
Connection of the source equipment
One or two stereo sources with RCA high level out-
puts may be connected to the two stereo RCA
inputs "AUDIO INPUT" (9). Use standard RCA cables.
The output connectors of the source devices are
often labelled "LINE OUT". The input connectors of
this amplifier (9) are electrically identical high level
inputs with RCA sockets whose signals are mixed
together internally. There is no option to switch bet-
ween the two RCA sources.
Connection of a recording device
If desired you can connect to the RCA sockets "REC
OUT" (10) (on the back of the device) a stereo rec-
ording device (e.g. CD recorder, tape recorder etc.)
or another device that is to receive the unchanged
stereo output level (line level) of the sources. The
signal emitted via this output consists of the mix
signals on the two RCA inputs (9) and, if a suitable
microphone is connected, the microphone signal.
The output level at the recording output is indepen-
dent of the volume setting and tone control (BASS,
36