DHC BT551 Handbuch Seite 12

immediately.
BAD CELL & REPLACE
BAD CELL & REPLACE
The battery has at least one
××.××V ×××× SAE
cell short circuit. It should be
replaced immediately.
NOTE that there might be some messages displayed to
different circumstances as below.
LOAD ERROR
The tested battery is bigger than
LOAD ERROR
2000CCA or 200AH. Or the
clamps are not connected properly.
Please fully charge the battery and retest after excluding
both previous reasons. If reading is the same, the battery
should be replaced immediately.
24V SYSTEM PRINTING :
PRINT 24V SYSTEM
To print 24V system test result,
user must save the test result
RESULT? YES
first. The test result will be
recorded until you connect to 12V battery. The message
to check printout will be displayed after you reconnect to
battery.
- GB.12-V1 -