Glomar HPO 6-300/240 Bedienungsanleitung Seite 24

Instruction Manual HPO 6-300/240
_____________________________________________________________________________
5.6. Reference as to which spare parts can be exchanged by the customer
Within the determined use of the tool only the dies (Pos.-No. 7) are permitted to be changed
by the customer.
6. Troubleshooting
a.) The dies (Pos.-No. 7) came to a standstill during the crimping process respectively the
crimping tool doesn't reach the final operating pressure
=> Actuate the pump lever (Pos.-No. 3) and simultaneously push the retract lever
(Pos.-No. 4).
b.) The tool loses oil.
=> Return the tool to the manufacturer. Do not open the tool and damage the seal of
the tool.
l l
Glomar AG Seestrasse 11 CH-9326 Horn
l l
T +41 71 841 70 70 www.glomar.ch
page 24
24