Technical Data; Inserting/Replacing The Batteries; Initial Operation - Bosch GIM Professional 60 Originalbetriebsanleitung

OBJ_BUCH-2461-001.book Page 13 Monday, April 20, 2015 4:52 PM

Technical Data

Digital level
Article number
Dimensions
– Length
– Width
– Height
Measuring range
Measuring accuracy
– 0°/90°
– 1–89°
Operating
temperature
Storage temperature
Batteries
Rechargeable
1)
batteries
Operating time,
approx.
Weight according to
EPTA-Procedure
01/2003
Automatic switch-off
after approx.
IP 54 (dust and splash
proof)
1) Due to the lower voltage of the rechargeable batteries, the battery
indicator will not display a full charge.
The measuring tool can be clearly identified with the serial number 2 on
the type plate.
Assembly

Inserting/Replacing the Batteries

Using alkali-manganese or rechargeable batteries is recom-
mended for operation of the measuring tool.
To open the battery lid 3, press on the latch 4 and fold the bat-
tery lid up. Insert the batteries. When inserting, pay attention
to the correct polarity according to the representation on the
inside of the battery lid.
Battery Indicator
The rechargeable battery/battery indicator f always displays
the current battery status:
The battery is over 90 % charged
The battery is between 60 % and 90 % charged
The battery is between 30 % and 60 % charged
The battery is between 10 % and 30 % charged
The empty battery indicator flashes. The battery
charge status is under 10 %. You can measure for ap-
proximately another 15–20 minutes from when the
flashing begins until the tool shuts down.
Always replace all batteries/rechargeable batteries at the same
time. Do not use different brands or types of batteries/re-
chargeable batteries together.
 Remove the batteries/rechargeable batteries from the
measuring tool when not using it for longer periods.
When storing for longer periods, the batteries/rechargeable
batteries can corrode and self-discharge.
Operation

Initial Operation

 Protect the measuring tool against moisture and direct
sun light.
 Do not subject the measuring tool to extreme tempera-
tures or variations in temperature. As an example, do not
leave it in vehicles for a long time. In case of large variations
in temperature, allow the measuring tool to adjust to the am-
bient temperature before putting it into operation. In case of
extreme temperatures or variations in temperature, the ac-
curacy of the measuring tool can be impaired.
 The contact surfaces and contact edges of the measur-
ing tool must be clean. Protect the measuring tool
against impact and shock. Debris particles or deforma-
tions can lead to faulty measurements.
Bosch Power Tools
GIM 60
3 601 K76 700
608 mm
27 mm
59 mm
0–360° (4 x 90°) 0–360° (4 x 90°)
±0.05°
±0.2°
–10 °C ... +50 °C –10 °C ... +50 °C
–20 °C ... +70 °C –20 °C ... +70 °C
4 x1.5V LR6(AA) 4 x1.5V LR6(AA)
4x1.2 V HR6(AA) 4 x1.2V HR6(AA)
100 h
0.7 kg
30 min

1 609 92A 11S | (20.4.15)
English | 13
GIM 120
3 601 K76 800
1250 mm
27 mm
59 mm
±0.05°
±0.2°
100 h
1.3 kg
30 min
