Herunterladen Inhalt Inhalt Diese Seite drucken

Verpolung Auf Lv-Seite Lv-Reverse Polarity - Brusa BSC624-12V-B Betriebsanleitung

Dc/dc – wandler
Inhaltsverzeichnis

Werbung

Validierungsbericht BSC624-12V-B
7.5
Verpolung auf LV-Seite
LV-reverse polarity
7.5.1
Testaufbau
Test setup
7.5.2
Messaufbau
Measurement setup
7.5.3
Messbedingungen
Measurement conditions
7.5.4
Ergebnis
Result
BSC624-12V-B_Validation report_110406.docx
MM1: Metrahit 23S 16A unfused
A
BSC624-12V-B
1)
MM2
V
HV
Device Under Test
AUX-Supply, CAN
1)
MM4
and RS232
A
Control Interface
connected via
testbox
Brusa-No. 149
Oszilloskop: Agilent Technologies DSO6034A (Brusa-Nr.
367)
CH1: U
(Agilent Tastkopf 10:1)
LV
Trigger auf fallende Flanke von CH1
Testgerät:
BSC624-12V-B Nr. 016 mit Firmware "SW-FW-BSC6-
04-00-00 T05" programmiert; Gerät im Standby-
Betrieb (CAN-Enable = OFF)
LV-Speisung:
12V/220Ah Bleibatterie (Brusa-Nr. 378)
U
= 12.5V
LV
Kühlung:
Testgerät nicht gekühlt
Bei verpoltem Anschluss der LV-Batterie wird durch die
LV-FETs der Trafostufe ein Kurzschluss verursacht, was
zum unmittelbaren Auslösen (<1s) der internen LV-
Sicherung führt. Der Sicherungsdefekt hat aber zur Folge,
dass aufgrund der Leitungsinduktivität an den LV-
Klemmen eine negative Spannungsüberhöhung von bis zu
-60V entsteht.
LV+
Contactor
1)
MM3
No. 016
V
LV- (Housing)
Oscilloscope: Agilent Technologies DSO6034A (Brusa-
No. 367)
CH1: U
Trigger on negative edge of CH1
Device under test:
LV-power supply:
Cooling:
When the device is connected to the battery with reverse
polarity a short-circuit is caused by the LV-FETs of the
transformer stage which directly (<1s) blows the internal
LV-fuse. The defect of the fuse however results in an neg-
ative overshoot of the voltage at the LV-terminals of up to
-60V which is caused by the cable inductance.
155 / 161
Validation report BSC624-12V-B
1)
Valid meters:
- Metrahit 23S, 28S, 29S
- Agilent U1253A
Lead Acid
Meters:
Battery
- Metrahit 23S:
Brusa-No. 378
- Metrahit 29S:
12V/220Ah
- Agilent U1253A:
(Agilent probe 10:1)
LV
BSC624-12V-B No. 016 programmed with firmware
"SW-FW-BSC6-04-00-00 T05"; device in standby-
operation (CAN-Enable = OFF)
12V/220Ah lead-acid battery (Brusa-No. 378)
U
= 12.5V
LV
Device under test not cooled
Brusa-No.:
004, 332
401, 404
528, 537, 539,
541, 542, 544

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis