Troubleshooting - Bosch Sensix'x DA50 Gebrauchsanleitung

Trouble shooting
problem
The iron does not
heat up.
"Auto off" indicator
lamp lashes.
The clothes tend to
stick.
Water drips out of
the soleplate
together with steam.
Steam does not
come out.
Spray does not
work.
Smoke comes out
when connecting the
iron for the irst time.
Deposits come out
through the holes in
the soleplate
If none of the above solves the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.
probable cause
1. Temperature control set to minimum.
2. No mains supply.
3. The "secure" system has been
activated. The iron is set to
stand-by.
• The "secure" system has been
activated. The iron is set to stand-by.
• The temperature is too high.
1. Temperature control setting is too
low.
2. Steam control is set too high in
conjunction with a low temperature.
3. You have pressed the shot of steam
button repeatedly without waiting for
5 seconds between each press.
4. Pure distilled water has been used
(see "Filling the water tankk"
section) or other products such as
fragrant water have been added to
the tank.
1. Steam control is set to "
position.
2. No water in the tank.
3. The temperature is too low.
Anti-drip system is activated.
1. No water in the tank.
2. Obstructed mechanism.
• This may be caused by the
lubrication of some of the internal
parts.
• Traces of lime scale are coming out
of the steam chamber.
Solution
1. Turn to a higher position.
2. Check with another appliance or
plug the iron into a different socket.
3. To reconnect the iron, just move it
about gently.
• To reconnect the iron, just move it
about gently.
• Turn the temperature control down and
wait until the iron has cooled down.
1. Turn the temperature control to a
higher setting (between "••" and "max")
and wait until the lamp goes out.
2. Set the steam control to a lower
setting.
3. Wait 5 seconds between each press
of the jet of steam button.
4. Mix distilled water with tap water as
directed in the "Filling the water tank"
section and never add any other
products to the water tank (unless
recommended by Bosch).
1. Set the steam control to an open
"
steam position.
2. Fill the tank.
3. Set to a higher temperature if
compatible with the fabric.
1. Fill the water tank.
2. Contact the Technical Service.
• This is normal and will stop after a
few minutes.
• Carry out a cleaning cycle (see
"Calc'n clean" section).
17
B OS CH