Q Acoustics Q3070S Benutzerhandbuch Und Produktspezifikationen Seite 19

Introduction
Thank you for purchasing Q Acoustics.
This manual is intended to take you through setup and installation and will help provide optimum
performance from the product.
Please read the instructions, important safety information and warnings carefully before installation
and use, to ensure the safe and satisfactory operation of this product.
We hope you enjoy the Q Acoustics experience.
The Q Acoustics 3000 series is a range of loudspeakers designed to meet the highest expectations of
dedicated 2-channel audiophiles and discerning movie enthusiasts.
The range comprises:
3010: Compact bookshelf speaker with a 100 mm bass driver.
3020: Bookshelf speaker with a 125 mm bass driver.
3050: Floorstander with two 165 mm bass drivers
3070S: 140 Watt active subwoofer with 2 x 165 mm drivers.
3090C: Centre channel with 2 x 100 mm bass drivers.
3050 speakers are bi-wireable. All the loudspeakers may be operated close to TV monitors with no ill-
effects with the exception of the 3070S which should not be operated within 500mm of TV screens
monitors or other magnetically sensitive equipment. Plasma and LCD screens are unaffected.
Before making any connections to your loudspeakers make sure that all active units in your system are
switched off at the mains.
When switching on your sound system or changing input sources, set the main volume control at a low
level. Turn up the level gradually.
Never play your sound system at full volume. The position of the volume control is deceptive and does
not indicate the power level of the system. Using very high volume settings may damage your hearing.
Do not connect your loudspeaker terminals to the mains supply.
Do not expose your loudspeakers to excessive cold, heat, humidity or sunlight.
If you play your loudspeakers without their grilles on, be careful to protect the drive units from damage.
Do not use makeshift stands. Fit the Q Acoustics dedicated stand according to the instructions and
using any fixings provided. Your dealer will advise you.
Do not dismantle the loudspeaker. You will invalidate the warranty.
Unpacking your loudspeakers
Unpack the speakers fully. Lift the speakers from the cartons by holding the cabinets. Do not touch the
driver units or use the protective bags to lift them. The 3050 and 3070S are heavy - get assistance to lift
them if necessary.
When manoeuvring loudspeakers, do not drag them across the floor as this may cause damage - lift
them before moving them.
In the carton you will find: The loudspeaker/s and this product manual.
In addition the packing for the following models contains:
3050: Rear stabiliser and spike covers for each speaker. An Allen key to adjust the spikes once fitted.
3070S: A mains power cord or cords, spikes and spike covers.
Check the product carefully. If any items are damaged or missing, report this to your dealer as soon as
possible.
Retain the packing for future transport. If you dispose of the packing, please do so following all recycling
regulations in your area.
3