Installation
GB
5.2 RGTF/RGTKF installation
Fig. 7: Installation of the RGTF/RGTKF room controller
30
The following diagram shows the installation of the RGTF/RGTKF room controller.
1. Undo snap hinge closure of lower clamp
2. Remove upper part from lower part
3. Attach wall mounting bracket at the intended location
4. Connect upper and lower part of clamp
5. Open battery compartment, remove isolating strip, close battery compartment
6. Push room controller into the wall mounting bracket
RGT B/RGTK B and RGTF B/RGTKF B room controller
136 231 03.11