Iv- Temperature Setting - Klimawatt EuroCave V166 Gebrauchsanweisung

7 - C
IV - Temperature setting
Setting the temperature of your wine cabinet can only be carried out inside the wine cabinet from control panel.
Temperature
display
Confirmation button
To adjust the temperature of your cabinet:
• Press and hold down the
• Set the desired temperature by pressing the
• Confirm your programming by pressing and holding down the "P" button for a few seconds.
Your programming will be automatically confirmed if no button is pressed within the 15 seconds following programming.
The recommended temperature range for storing and maturing wine is 50 to 57°F.
However, it can be set between 48 to 59°F.
To operate correctly, your cabinet should be located in a room with a temperature
between 32°F and 95°F.
When there has been a significant modification in set temperatures, it can take several hours for your wine cabinet to stabilise and display the desired
temperature.
The performance of wine cabinets is optimized when they are loaded to at least 75% of their maximum capacity.
- You have loaded your cabinet with a large number of bottles: it takes several hours for your cabinet to reach the right temperature.This could happen when
first starting up the cabinet, this is not due to an operating fault.
If, however, after a few days, the problem persists, contact your EuroCave (or Around Wine) dealer.
N.B: Only prolonged exposure to excessive temperatures or violent fluctuations in temperature will harm your fine 'crus'.
12
OMMISSIONING YOUR WINE CABINET
On/Off button
button for a few seconds.The symbol "SPI" will appear alternatively with the previous temperature setting.
and buttons.
Adjustment buttons
• Temperature display: Displays the current temperature
inside your wine cabinet.
• Adjustment buttons (
temperature inside the cabinet.
• Confirmation button "P": confirm the setting temperature.
• On/off button: "U" switches the wine cabinet on and off.
/ ) sets the desired