Ii- Assembling The Handle; Iii- Door Reversibility - Klimawatt EuroCave V166 Gebrauchsanweisung

5 - I
NSTALLING YOUR WINE CABINET
II - Assembling the handle
1
2
3
In order to correctly assemble your wine cabinet's handle, please refer to the following instructions.
4
Prepare the items required for assembling, supplied with your cabinet:
- the handle (1),
- 2 washers (2),
- 2 screws (3),
- 2 caps (4).
You will also need a flathead screwdriver (not supplied)
Instructions:
1. Place 1 washer on 1 screw.
2. Insert the screw in the screw hole located on the inside of the wine cabinet door,
3. Using the screwdriver, carefully screw and tighten the screw in the post of the handle.
4. Repeat the procedure for the other handle post.
III - Door reversibility
1
2
3
a - Parts summary
1 - 2: grommets
3:Torx screws 25
4: upper hinge
5
5: lock receiver
4
b - Door reversibility
Your wine cabinet door is reversible. In this way you can change which way it opens.
• Close the door
• Remove the grommets, see Fig.A.
• Remove the torx screws and the upper hinge.
• Lift and take off the door and put it to one side
• Remove the pin with a spanner (Fig. B).
• Carefully remove the plug with a thin blade and in its place fit the
pin and washer (Fig. B).
Fig.A
• Replace the plug on the opposite side (Fig. B).
• Remove the door catch and screws (Fig.C).
• Locate the foot on the other side of the housing using the screws.
• Turn the door through 180°
WARNING: the glazed doors are very heavy.Take all necessary
precautions not to injure yourself or drop the door. Never place it on its edges, which
may break it.
• Position the door onto the pin of the lower hinge. Hold the door against the door seal.
• Place the pin of the upper hinge in the corresponding slot of the door.
• Fit the 3 screws. Ensure that the hinge is fixed properly into place, if not adjust it. See
Fig.D.
Fig.B
• Fit the 3 grommets.
In case of solid door reversibility, remove the EuroCave plate and put it in the high
position. If the plate is damaged, contact your EuroCave distributor to order a new one.
• Wait 48 hours before plugging in.
Fig.C
Fig.D
8