Maintenance - Klarstein 10029344 Bedienungsanleitung

Setting the temperature (press this key twice in working conditition)
2x
• The light indicator
the temperature by pressing the „UP (+)" and „DOWN (-)" key. The range of tempera-
ture is from 15 to 28 °C.
• Press SET key to quit temperature setting, and the temperature that you have set will
be effect at once.
• ) If no operation to the keys after 5 seconds or press other keys except „UP (+)" and
„DOWN (-)" then the LED indicator will show room temperature.
Functioning of temperature and timer function
• If the temperature is ≤-10 °C, then it will show "LO". If the temperature is over 40 °C, then it will show "HI".
• The device will not judge the temperature within 10s when power on the device. After the device work for
10s, if the ambient temperature reaches or over the temperature that has been set, the heating function
will turn off, the low/high heating power light will be off, and the fan will be off in 10 seconds. If you have
pressed Swing, it will turn off as well. For the other indicators will not change.
• If the ambient temperature decreased, and 2 °C lower than the temperature that has been set, the heat-
ing function will be on again, as well as the fan & the swing function (if you have pressed Swing before).
Also the other indicators will be on.
• If the ambient temperature reaches or over the automatically setting temperature 25 °C, then the device
will work when you set the temperature over 25 °C.
• When setting the time & temperature at the same time, it will show in a circle, time show 30 seconds, and
not show temperature. Then the temperature is shown for 30 seconds instead of the time. If you do not
set the timer or set the timer to 0, then time will not show.
Changing the battery
• Pull out the battery door at the back side of remote control.
• Pay attention to the battery polarity, and insert the battery (CR2032) to the tray of the door .
• Push the battery door into the remote control.
will be on. The LED will flicker twice a second. You can change

Maintenance

16