Installation - Velleman CAMCOLVC17 Bedienungsanleitung

6.

Installation

You can use the camera while holding it in your hand. Fit the camera
into the protection sleeve [9] and attach a lanyard to the hanging
ring [2] so you can carry it around easily.
Or you can fix the camera to a wall as follows:
1. Fix the bracket [10] to the wall using screws. Note: you can
also use Velcro or magnetic strips.
2. Attach the clip [11] to the back of the camera.
3. Attach the camera to the bracket [10] using the clip [11].
4. Adjust the viewing angle of the camera.
Caution: Do not aim the camera at the sun or other extremely
bright objects.
7. Operation
Turning the camera on and off
• To switch on the camera, place the power switch [3] in the ON
position.
• To switch off the camera, place the power switch [3] in the OFF
position.
If the camera is idle for more than 1 minute, it switches off
automatically.
Inserting a micro SD card
1. Switch the camera off.
2. Insert a micro SD card (not included) in the card slot [5]. Push
it in until it clicks into place.
3. To remove the micro SD card again, push it gently so that it
pops out.
Using the video function
1. Switch the camera on.
2. Set the mode switch [4] to Video.
3. Press the record button [8] to initialise the camera.
The LED lights blue during initialisation. When the camera is
ready, the LED lights orange continuously.
4. To start recording, briefly press the record button [8].
The LED flashes blue during recording.
5. To stop recording, press the record button [8] again.
The camera saves the video file on the memory card.
V. 01 – 13/07/2012
CAMCOLVC17
5 ©Velleman nv