Kingstone Atlanta 650 Bedienungsanleitung Seite 9

ATLANTA 650 BDA 23.11.16
Warning:
Before attempting to light your gas grill you must refer to your lighting instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be faulty in
any way do not attempt to use your gas grill.
When changing your gas cylinder ensures that there are no sources of ignition close by i.e. fires, cigarettes,
naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting which will affect the gas flow when using your gas grill.
Also the hose must not have undue tension and must not touch any part of the gas grill which may be hot.
Please choose flexible hose whose heatproof higher than 80 °C
Every 2 years changing the flexible hose when the national conditions require it.
How to connect a gas cylinder
a) Turn the orange cap so that the arrow is pointing to the gap in the shroud.
b) Remove the orange safety cap by pulling the lanyard out, then out.
Do not use tools. Leave the cap hanging.
c) Check that the black sealing washer is fitted inside the cylinder valve.
Place the regulator down over the valve with switch.
d) Turn the switch clockwise on gas cylinder-then turn on the gas grill as instructed.
Warning: Always test gas line for leaks at connector with soap water finishing all connections.
How to disconnect a gas cylinder
a) Except for twin-cylinder installations with a changeover valve, turn off the gas tap if fitted to the appliance.
Wait until the burner and pilot light have gone out. For installations with a changeover valve, it is only necessary
to switch off the empty cylinder.
b) Replace the orange safety cap onto the empty cylinder.
GENERAL
Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas tightness check must
be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied
to the unit. Periodically check the whole system for leaks following the procedures listed below. If the smell of gas is detected
at any time you should immediately check the entire system for leaks.
BEFORE TESTING
Make sure that all packing material is removed from the grill including tie-down straps.
16:13 Seite 9
9