English; Getting Started; Other Functions - AEG UltraMix Anleitung

ENGLISH

Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories and
spare parts. They have been designed especially for your product. This product is designed with the environment in
mind. All plastic parts are marked for recycling purposes.
ACCESSORIES INFORMATION
The Meat Grinder and Express Slicer accessories are only included in the model KM4700. Other models from the
KM4xxx series can be used with these accessories, but they need to be bought separately.
COMPONENTS
A. Motor head (tiltable)
B. Speed selector
C. Housing
D. Tilt head locking lever
E. Working light
F. Attachment hub
G. Attachment shaft
H. Stainless steel bowl
Picture page 2-3

GETTING STARTED

1
Before using the appliance for the first time: Unplug the appliance. The Wire whip, Meat grinder* and Slicer/Shred-
der* should only be washed by hand in warm soapy water. T he bowl, Flat beater and Dough hook are dishwasher-
proof. Clean the motor unit with a damp cloth. Caution: Never immerse the motor unit in water! Let all parts dry
thoroughly.
2
Place the appliance on a flat surface. Tilting the Motor head up: Move the Tilt head locking lever to "Unlocked" with
one hand, tilt the Motor head up with the other hand. Once in up position it locks. Warning: Keep fingers and hands
away from areas with movable parts.
3
Move Speed selector to "OFF". Place the Stainless steel bowl on the bowl clamping plate. Move the bowl clockwise
to lock into position. Warning: Never operate appliance with the attachments wire whip, flat beater or dough hook
unless the bowl is in place.
4
Place an attachment on the Attachment shaft: Align the slot at the top of the attachment with the pin on the
Attachment shaft. Push attachment up and turn it counterclockwise until the pin is locked into position. To remove
attachment, move it clockwise and pull off.
5
Tilting the Motor head down: Move the Tilt head locking lever to "Unlocked" with one hand, tilt the Motor head
down with the other hand. Insert the plug in the main socket.
6
Move the Speed selector from "OFF" to desired speed (1-10). Once mixing is complete, turn the Speed selector to
"OFF" and unplug the appliance.
7
Work light and Power indicator light: If the appliance is plugged in and a speed is selected, a blue LED lights up
around the Speed selector. A work light will also light up over the working area. If the Speed selector is moved to
"OFF", the working light will automatically shut off after 3 min.
8
Note: If the Speed selector is already turned on before the appliance is plugged in, both the blue Speed selector LED
light and the Work light will flash OFF and ON to let you know the Speed selector has been left on. Turn the Speed
selector to "OFF" and the lights will stop flashing. Then resume operating normally.

OTHER FUNCTIONS

9
Attachment hub: The appliance comes with a built in multipurpose Attachment hub. Read and carefully follow the
instructions that comes with each attachment for correct and safe use.
10
Adjusting the Attachment shaft: The appliance is adjusted at the factory so that the Flat Beater clears the bottom
of the Bowl. If the Flat Beater hits the bottom of the Bowl or is too far away from the sides, you can adjust it correctly.
See 11 for further instructions.
www.aeg.com
KM4xxx_StandMixer_AEG NO-FARSI.indd 6
I. Bowl clamping plate
J. Non-slip feet
K. Power cord
L. Wire whip
M. Coated flat beater
N. Coated dough hook
O. Meat grinder*
P. Slicer/Shredder*
*depending on model
6
2017-07-06 13:02:06